To practice problem-solving strategy 26.1 resistors in series and parallel. two bulbs are connected in parallel across a source of emf e = 11.0 v with a negligible internal resistance. one bulb has a resistance of 3.0 ï , and the other is 3.0 ï . a resistor r is connected in the circuit in series with the two bulbs. what value of r should be chosen in order to supply each bulb with a voltage of 2.4 v ?

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?