Answers: 1
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
Physics, 23.06.2019 01:00, Bettie55
During the apollo moon missions, astronauts were concerned about the effects of newton's third law of motion when: o a. they ejected waste water, because they were concerned that it would push them off course. o b. they reentered earth's atmosphere, because they were carrying heavy moon rocks. o c. they took off from earth, because a large force was required to generate large acceleration. o d. they detected incoming space debris, because the inertia of the debris could damage their ship.
Answers: 3
a pushing force of 10 000 n is applied to the backside of a car at an angle of 25.0° above the horiz...
Mathematics, 12.03.2021 15:50