subject
Physics, 08.01.2021 21:20 naeaamm2528

A vector points -43.0 units along the x-axis , and 11.1 units along the y-axis. Find the direction of the vector.

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 19:30, davidsteck99
A33.1 g copper object is launched from a 1.5 m 30° steel incline positioned on the floor by being pulled up a string attached to a 50.0 g mass suspended vertically over a pulley. the object is projected towards a glass table where it lands when it is at the point along its trajectory with the lowest speed. it comes to a halt when it clears the opposite edge of the table. it then falls and lands on 9 physics texts each 5 cm thick that are stacked on the floor on the opposite side of the table. assume that the table does not have a ledge and the rectangular object experiences 0.05 n of air resistance as it falls towards the books. how far and how long did the object travel and how fast does it hit the books. assume that at the moment the copper object leaves the incline, the massless string and ideal pulley break off
Answers: 2
image
Physics, 21.06.2019 23:00, hunterdylan01
Acoal-fired plant generates 600 mw of electric power. the plant uses 4.8 x 10^6 kg of coal each day, and the heat of combustion of coal is 3.3x 10^7 j/kg. the steam that drives the turbines is at a temperature of 300° c, and the exhaust water is at 37° c. (a) what is the overall efficiency of the plant for generating electric power? (b) how much thermal energy is exhausted each day? (c) what is the change in entropy of the universe for this heat engine? (d) using the same heat reservoirs, what is the maximum possible (carnot) efficiency for a heat engine?
Answers: 1
image
Physics, 22.06.2019 01:10, caguil00
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
image
Physics, 22.06.2019 01:30, ladyty2109
Kate is working on a project in her tech education class. she plans to assemble a fan motor. which form of energy does the motor convert most of its electric energy into? a. light energy b. motion energy c. sound energy d. thermal energy
Answers: 1
You know the right answer?
A vector points -43.0 units along the x-axis , and 11.1 units along the y-axis. Find the direction o...

Questions in other subjects:

Konu
Mathematics, 12.12.2020 19:00
Konu
Mathematics, 12.12.2020 19:00