The crested goshawk is an amazing predator, as i learned from watching the smithsonian channel. like most raptors, it performs aerial reconnaissance and attacks small animals. the show claimed the goshawk could spot its prey up to a few miles away. which got me how big is its prey? ? assume the goshawk’s pupil has a diameter of 7.00 mm, that it sees light of wavelength 450 nm and that the prey is 5.00 km away (about 3 miles). what is the size of the smallest animal it can possibly see? (for comparison, the goshawk is about 18 inches, or 40 cm, tall.)

Molten iron fills a mould, which has a volume of 200 cm cubed. calculate the volume when the iron cools and solidifies.

Jason and mia are both running in a race. as they approach the finish line, you being the physicist that you are decide to time how long it takes them to reach the end of the race. when you start your stop watch (you can take this as time t = 0 s) you notice that mia is an unknown distance d ahead of jason and both are moving with the same initial velocity v_0. you also notice that jason is accelerating at a constant rate of a_j, while mia is deaccelerating at a constant rate of -a_m. jason and mia meet each other for the first time at time t = t_1. at this time (t = t_1) jason's velocity is two times that of mia's velocity, meaning v_j (t_1) = 2v_m (t_1). a) draw the position vs. time graph describing mia's and jason's motion from time t = 0 to time t = t_1. clearly label your axes and initial conditions on your graph. b) draw the velocity vs. time graph describing mia and jason's motion from time t = 0s to time t = t_1. clearly label your axes and initial conditions on your graph. c) how long from when the stop watch was started at t = 0s did it take mia and jason to meet? express your answer in terms of know quantities v_0, a_m, and a_j. d) when the stop watch started at time t = 0s, how far apart, d, were mia and jason? express your answer in terms of know quantities v_0, a_m, and a_j.

Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?