Engineering, 10.10.2021 14:00 allyyzz
In the design test, a light sawtooth belt is wound around a sprocket (sawtooth wheel) with an average radius of r = 20 cm. The belt is horizontal and angular a = 15°, and both ends are fixed to the right vertical wall. Initially, the tension of the upper and lower belts is equal to T0 = 100 N. Find the tension T1 and T2 acting on the upper and lower belts when applying counterclockwise moment M = 10 N*m to the sprockets, respectively.
Answers: 3
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10, alyssabailey7545
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
In the design test, a light sawtooth belt is wound around a sprocket (sawtooth wheel) with an averag...
Mathematics, 25.11.2020 03:40
Mathematics, 25.11.2020 03:40
History, 25.11.2020 03:40
English, 25.11.2020 03:40
Mathematics, 25.11.2020 03:40
Mathematics, 25.11.2020 03:40