subject
Engineering, 18.04.2021 06:00 robert7248

Choose a jet aircraft to use as your example for this activity. It should not be an exotic jet aircraft, as you will need to find data online for the aircraft. If you choose a military aircraft, make sure you are not using classified data to support your work. Only use data that is available to all on the internet. You will then use the data you gathered for this particular aircraft to show examples of your performance problems and how you derived them. To provide an outlook to some of the aspects of next module's unaccelerated performance, select a jet aircraft of your choice, choose three (3) of the following items of performance, and prepare an instructional presentation (utilizing a presentation tool of your choice - see resources in the Online Tools section) that explains in-depth how to find these different items of performance for a jet aircraft. This will be a standalone presentation and will not be attached to your comprehensive presentation project. Available choices:

maximum forward speed in level flight
absolute ceiling
best angle of climb airspeed
angle of climb
best rate of climb airspeed
rate of climb
maximum endurance airspeed
maximum range airspeed
influence of weight on performance
influence of altitude on performance
influence of configuration on performance

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
image
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
image
Engineering, 04.07.2019 19:10, nayi2002
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
You know the right answer?
Choose a jet aircraft to use as your example for this activity. It should not be an exotic jet aircr...

Questions in other subjects:

Konu
Social Studies, 24.10.2019 04:20
Konu
Biology, 24.10.2019 04:20