subject
Engineering, 08.10.2020 09:01 lloveshan219

A Palm Spring golf course has requested a permit to install a 40000 ft2 pond to enhance the beauty of its facilities. Since the evaporation rates are very high in Palm Springs, it is likely they will need to pump a lot of groundwater to keep the pond full. The city has hired you (a water resources engineer) to determine how much water needs to be pumped per year in order to keep the pond filled. There is a small creek that discharges an average of 0.25 m3/s into the pond. The outlet valve from the pond releases an average rate of 0.30 m/s (to keep the pond from getting stagnant) Precipitation on the pond is 260 mm/year, and the annual evaporation is estimated to be 105 inches/year. The pond will be lined with concrete to prevent any drainage from the bottom .Using a water balance what volume on average of ground water must be added to take each year to keep the pound at constant level? Draw scematic of the problem to identify the control volume and relevent fluxes. Clearly write out or define your water balance equation and varibles along with any assumptions you make.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
image
Engineering, 04.07.2019 18:10, 19deleonl
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
You know the right answer?
A Palm Spring golf course has requested a permit to install a 40000 ft2 pond to enhance the beauty o...

Questions in other subjects:

Konu
Chemistry, 24.06.2019 09:00
Konu
Mathematics, 24.06.2019 09:00