Engineering, 18.04.2020 04:11 Savagepanda911

The label on a bleach bottle states that it contains 5.25% (by mass) sodium hypochlorite (NaOCl). Assume that the bleach is manufactured by adding this chemical to otherwise pure water. Take the density of bleach to be the same as that of pure water, 1.0 g cm^-3. Assume that the NaOCl dissociates completely and the pKa for hypochlorous acid is 7.6.

a. What is the pH of bleach?
b. Bleach can be used as an emergency disinfectant for example, for water after an earthquake. Assume that the target dose of free residual chlorine (HOCI + OCI-) to be added is 50 g m^-3. How much bleach (in cm^3) would you add to 1 L of water to disinfect it?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

You know the right answer?

The label on a bleach bottle states that it contains 5.25% (by mass) sodium hypochlorite (NaOCl). As...