Engineering, 14.09.2019 00:10 powerprefection4114

A30mm square tubing is to be welded to a steel frame and is loaded by a tension of 2kn and a bending moment of 300nm. the weld material is e7020 and the steel tube is aisi-1050 hr. determine the minimum thickness of the tube material for a factor of safety of 2. note this is not the weld. determine the minimum size weld assuming that the tube is welded all around.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

You know the right answer?

A30mm square tubing is to be welded to a steel frame and is loaded by a tension of 2kn and a bending...