subject
Engineering, 26.07.2019 19:20 WallaceHarrison123

Amultiple disk clutch, steel on bronze, is to transmit 5 hp at 750 rpm. the inner radius of contact is 1.5 in and the outer radius of contact is 2.75 in. the clutch operates in oil with an expected coefficient of friction 0.10. (oil is used to give smoother engagement, better dissipation of heat, even though the capacity is reduced.) the average allowable pressure. is 50 psi, maximum. (how design pressures are used to provide for sufficient size to give yood heat dissipation capacity.) assuming uniform wear, determine the following: a) how many total dishes of sted and bronze are required? b) what axial force is required? c) what is the average pressure?

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 06.07.2019 03:30, relic7391
The load on a bolt consists of an axial pull of 10 kn together with a transverse shear force of 5 kn. the bolt material has a yield strength of syt syc 100 mpa. find the diameter of the bolt at factor of safety n-0.5, n 1 and n-2 using maximum shear stress theory
Answers: 3
image
Engineering, 06.07.2019 04:10, mooneyhope24
Ir at sea level and 30°c and 50% relative humidity flows at a rate of 1 kg/s through a cooling coil that has an apparatus dewpoint of 10°c. the air leaves the coil at 15°c. determine the following: 3.1)- relative humidity of the air leaving the coil; 3.2)- moisture content of the air leaving the coil; 3.3)- sensible heat factor; 3.4)- total heat transfer rate; 3.5)- sensible heat transfer rate 3.6)- latent heat transfer rate
Answers: 1
image
Engineering, 06.07.2019 05:10, j0162
The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c
Answers: 2
image
Engineering, 06.07.2019 05:10, amohammad6
Air at 27°c and at atmospheric pressure flows over a fat plate at a speed of 2 m/sec. if the plate is maintained at 93°c, calculate the heat transfer for unit wid h of the plate; assuming the length of the plate along the flow of air is 2 metres.
Answers: 3
You know the right answer?
Amultiple disk clutch, steel on bronze, is to transmit 5 hp at 750 rpm. the inner radius of contact...

Questions in other subjects:

Konu
Mathematics, 04.05.2020 23:59
Konu
Mathematics, 04.05.2020 23:59