Computers and Technology, 02.03.2021 14:00 boss1373

Give atleast 5 collavorative tools

Answers: 1

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 23.06.2019 11:30, leapfroggiez

Auser is given read permission to a file stored on an ntfs-formatted volume. the file is then copied to a folder on the same ntfs-formatted volume where the user has been given full control permission for that folder. when the user logs on to the computer holding the file and accesses its new location via a drive letter, what is the user's effective permission to the file? a. read b. full control c. no access d. modify e. none of the above

Answers: 1

continue

Computers and Technology, 23.06.2019 14:30, kodak0531

Which of the following would not be considered a pc? a. mainframe b. desktop c. tablet pc d. laptop

Answers: 2

continue

Computers and Technology, 23.06.2019 14:30, soapai

Select the correct answer. sean is a computer programmer. he has programmed an application for toddlers that plays nursery rhymes. however, a logic error has occurred in the program. which problem is a likely consequence of the error? a. the program crashes every time the user wants to play the nursery rhymes. b. the program crosses its buffer boundaries and overwrites an adjacent program. c. the program plays a different nursery rhyme than the one the user intended to play. d. the program shows different structures in its programming language code. e. the program introduces new viruses every time the user plays a nursery rhyme.

Answers: 1

continue

Computers and Technology, 23.06.2019 15:30, jasssp

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Answers: 2

continue

You know the right answer?

Give atleast 5 collavorative tools...