subject

Chemistry, 30.04.2021 01:30 batoolishak7475

¿Qué volumen ocupa un gas a 980 mmHg, si el recipiente tiene finalmente una presión de 1,8 atm y el gas se comprime a 860 ml?

ansver

Answers: 1

Show answers

Other questions on the subject: Chemistry

Chemistry, 22.06.2019 11:00, familyvazquez7

What is the temperature of 0.750 mol of a gas stored in a 6,850 ml cylinder at 2.21 atm? . 2.95 k 5.24 k 138 k 246 k

Answers: 3

Chemistry, 22.06.2019 11:00, RidhaH

Which statement correctly identifies the scientific question and describes why the question is scientific? question 1 refers to the supernatural. question 2 reflects a moral or social value. question 3 refers to something that can be measured. question 4 reflects a question that can’t be observed.

Answers: 1

Chemistry, 22.06.2019 14:30, lorrainelopez

The three types is stress that act on earths rocks are compression, tension, and

Answers: 1

Chemistry, 22.06.2019 15:30, christopherluckey7

The reactions of photosynthesis occur in the of plant cell? a. mitochondria. b. lysosomes. c. chloroplasts. d. chlorophyll

Answers: 1

You know the right answer?

¿Qué volumen ocupa un gas a 980 mmHg, si el recipiente tiene finalmente una presión de 1,8 atm y el...

Questions in other subjects:

Konu

Engineering, 13.09.2019 22:30

Name the point of intersection, where the axis meet....

Konu

Engineering, 13.09.2019 22:30

Areciprocating compressor takes a compresses it to 5 bar. assuming that the compression is reversible and has an index, k, of 1.3, find the final temperature. charge of air at 1 ba...

Konu

Engineering, 13.09.2019 22:30

The yield of good chips in multiprobe for a certain batch of wafers is 75%. the wafers have a diameter of 300 mm with a processable area that is 280 mm in diameter. if the defects...

Konu

Engineering, 13.09.2019 22:30

Aball screw connected directly to a dc servomotor drives a positioning table. the screw pitch = 8 mm, and the optical encoder attached to it emits 120 pulses/rev of the screw. dete...

Konu

Engineering, 13.09.2019 22:30

Acone-shaped part is to be fabricated using stereolithography. the radius of the cone at its base = 35 mm, and its height = 50 mm. to minimize the staircase effect, layer thickness...

Konu

Engineering, 13.09.2019 22:30

Asilicon boule has been processed through grinding to provide a cylinder whose diameter 285 mm and whose length 900 mm. next, it will be sliced into wafers 0.7 mm thick usinga cut-...

Konu

Engineering, 13.09.2019 22:30

Calculate the angle of banking on a bend of 100m radius so that vehicles can travel round the bend at 50km/hr without side thrust on the tyres....

Konu

Engineering, 13.09.2019 22:30

Why is the receiving staff in a typical warehouse much smaller than the staff of order-pickers?...

Konu

Engineering, 13.09.2019 22:30

In no more than half a page, detail what you understand by the concept of fibre volume fraction in the context of a continuous fibre-reinforced composite. more specifically: (a) h...

Konu

Engineering, 13.09.2019 22:30

Why is free hand skecthing is important to understand....

More questions: Chemistry Another questions