Physics, 21.08.2019 09:20 BePaige

You need to put a metal rod
into a hole in a metal cylinder.
it is too tight. which would
be the best strategy to make
the rod fit? (use cooling and/or heating)

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 00:30, kate6218

Which type of wave can travel without a medium

Answers: 1

continue

Physics, 22.06.2019 03:30, itsRyanPlayzMC9660

Scout feels ill one day before school. her mother puts a thermometer in her mouth and the temperature begins to climb to 100°f. what is happening between the cooler thermometer and scout's body? a) scout's body is applying a force to the particles in the thermometer. b) kinetic energy is being transferred from her mouth to the thermometer. c) potential energy is being lost by the thermometer and gained by scout's body. d) the potential energy stored in foods is converted to mechanical energy to raise the mercury in the thermometer.

Answers: 1

continue

Physics, 22.06.2019 11:30, azduce

(2) (a) you have a simple circuit that consists of only a battery (δvbat=1.5v) and two resistors with resistance r1=10ω and r2=5ω, connected in series with each other. what is the current running through the battery? (b) you re-arrange your circuit so now r2 is attached in parallel to r1 rather than in series. what is the current running through the battery? (c) you add an additional resistor r3=7ω on the same branch as r2. what is the current running through the battery? (d) what is the power dissipated in r3?

Answers: 3

continue

Physics, 22.06.2019 12:50, starr3971

Air is contained in a variable-load piston-cylinder device equipped with a paddle wheel. initially, air is at 400 kpa and 17°c. the paddle wheel is now turned by an external electric motor until 75 kj/kg of work has been transferred to air. during this process, heat is transferred to maintain a constant air temperature while allowing the gas volume to triple. calculate the required amount of heat transfer in kj/kg.

Answers: 2

continue

You know the right answer?

You need to put a metal rod
into a hole in a metal cylinder.
it is too tight. which woul...