subject
Physics, 31.07.2019 22:30 deaishaajennings123

The acceleration of gravity on the moon is only one-sixth of that on earth. if you launch a tennis ball on the moon with the same the speed and angle that you would on earth, the ball would travel:

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 21:30, genyjoannerubiera
Ahydroelectric plant takes energy from water and turns it into electrical energy. what are the transformations of energy in the water molecules that are used in the process of generating electricity this way?
Answers: 3
image
Physics, 21.06.2019 22:00, markyyy53
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
image
Physics, 22.06.2019 09:00, Andy10201
Atelevision set that has been running for a while heats up even the air around it. which two laws of thermodynamics could be used to analyze this scenario
Answers: 1
image
Physics, 22.06.2019 15:30, tiffuuu
At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.
Answers: 1
You know the right answer?
The acceleration of gravity on the moon is only one-sixth of that on earth. if you launch a tennis b...

Questions in other subjects: