Physics, 02.08.2019 08:00 hastephens03

What are the constituent metals of stainless steel?

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 00:30, Solany6426

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Answers: 2

continue

Physics, 22.06.2019 09:00, alisonnn101

A2000 kg car is rounding a curve of radius 200 m on a level road. the maximum frictional force the road can exert on the tires of the car is 4000 n. what is the highest speed at which the car can round the curve?

Answers: 1

continue

Physics, 22.06.2019 09:00, pancho99

Inside of a windmill or a dam is a that is used to transform one type of energy into electrical energy. a. motor b. generator c. transformer d. power pack

Answers: 2

continue

Physics, 22.06.2019 09:40, goofy44

Aturntable a is built into a stage for use in a theatrical production. it is observed during a rehearsal that a trunk b starts to slide on the turntable 10 s after the turntable begins to rotate. knowing that the trunk undergoes a constant tangential acceleration of 0.31 m/s2, determine the coefficient of static friction between the trunk and the turntable.