Physics, 05.01.2022 01:00 jadalawler3

How many times is light refracted when it passes through a prism

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 02:10, kernlife

Astudent is performing an experiment comparing sound and light waves. the student gathers the following data. what conclusion does the student most likely make based on this data? light waves always travel the same speed; however, the speed of sound is determined by the medium that it travels through. all sound waves always have the same energy, so the temperature of the medium does not affect wave speed. light needs to vibrate particles, so it travels fastest in tightly packed solids, while sound does not need a medium, so it travels fastest in a gas. tightly packed particles in solids slow down the light waves; however, sound waves make particles bounce into each other, so they travel faster in solids.

Answers: 3

continue

Physics, 22.06.2019 13:00, rolo7105

What causes the formation of ocean currents?

Answers: 1

continue

Physics, 22.06.2019 21:10, ineedhelp2285

An athlete swings a ball, connected to the end of a chain, in a horizontal circle. the athlete is able to rotate the ball at the rate of 8.13 rev/s when the length of the chain is 0.600 m. when he increases the length to 0.900 m, he is able to rotate the ball only 6.04 rev/s. (a) which rate of rotation gives the greater speed for the ball? 6.04 rev/s 8.13 rev/s (b) what is the centripetal acceleration of the ball at 8.13 rev/s? m/s2 (c) what is the centripetal acceleration at 6.04 rev/s? m/s2

Answers: 2

continue

Physics, 23.06.2019 07:00, hockejoh000

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

continue

You know the right answer?

How many times is light refracted when it passes through a prism...