subject
Physics, 20.12.2021 19:40 kidkoolaidboy96291

The potential difference between the (high-voltage) inner shell of a Van de Graaff accelerator and a point where the charge is injected into the moving belt is 3.4 MV. What is the minimum power required to pull the belt when the belt transfers the charge to the case at 2.8 mC/s?

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 19:40, drcarver
You carry a 7.0-kg bag of groceries 1.2 m above the ground at constant speed across a 2.7m room. how much work do you do on the bag in the process? (a) 157j (b) 0.00j (c) 185j (d) 82j
Answers: 2
image
Physics, 21.06.2019 21:30, gabrielolivas59
The earth remains in orbit around the sun due to the force of gravity. how does the force of gravity exerted by the sun on the earth compare to the force of gravity exerted by the earth on the sun?
Answers: 1
image
Physics, 21.06.2019 22:30, mirellaenriquez5529
Follow these directions and answer the questions. 1. shine a pencil-thin beam of light on a mirror perpendicular to its surface. (if you don't have a laser light as suggested in the video, you can make a narrow beam from a flashlight by making a cone from black construction paper and taping it over the face of the flashlight.) how does the light reflect? how does the relationship of incident to reflected ray relate to the reflection of water waves moving perpendicular to a barrier? 2. shine a pencil-thin beam of light on a mirror standing on a sheet of paper on the table (or floor) so that you can mark the incident ray and reflected ray. (you can support the mirror from the back by taping it to a wooden block.) 3. mark a line on the paper representing the reflective surface. (the reflective surface of a mirror is usually the back edge.) 4. draw a dashed line perpendicular to the mirror surface at a point where the incident and reflected ray meet. this perpendicular is called a normal to the surface. 5. measure the angles between the rays and the normal. the angle of incidence is the angle formed by the incident ray and the normal to the surface. the angle formed by the reflected ray and normal is called the angle of reflection (r). what is the angle of incidence? what is the angle of reflection? 6. repeat for several different angles. (see report sheet for details.) what appears to be the relationship between the angle of incidence and angle of reflection? in science 1204, what was the relationship for these two angles made by the reflection of waves in a ripple tank? 7. roll a ball bearing so that it hits a fixed, hard surface (a metal plate) at several angles (including head-on). observe the way in which the ball bearing reflects. what generalization can you make about how a ball bearing reflects from a wall? have you proved that light can only behave like a wave?
Answers: 1
image
Physics, 22.06.2019 02:50, lilybear1700
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
You know the right answer?
The potential difference between the (high-voltage) inner shell of a Van de Graaff accelerator and a...

Questions in other subjects:

Konu
Mathematics, 13.12.2019 03:31
Konu
Mathematics, 13.12.2019 03:31
Konu
Mathematics, 13.12.2019 03:31