Physics, 13.12.2021 02:00 nathaniel12

In the United States, radioactive waste is divided into three main categories based on their activity, their heat generation potential, and what they physically contain. Low level radioactive waste is the least dangerous type of nuclear waste. It contains relatively small amounts of radioactive substances with short half-lives.

Which of the following methods is most commonly used to dispose of low level radioactive wastes?
A.
activating reactions so the material is no longer radioactive
B.
sealing the waste into steel tanks and burying the tanks deep into the ground
C.
compacting the waste and burying it in a shallow landfill
D.
sealing in a biohazard bag and disposing the bag with ordinary trash

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 15:40, frtjay

Translation can be considered to have three phases or steps: initiation, protein synthesis, and termination. give a detailed summary of the factors and molecules involved with each step and, where appropriate, compare/contrast the differences between prokaryotic and eukaryotic translation.

Answers: 1

continue

Physics, 21.06.2019 22:00, penaabel6202

Which units can be used to measure length or distance? check all that apply. gram meter kilometer liter inch

Answers: 1

continue

Physics, 22.06.2019 07:50, singhmanny3526

The ratio of lift to drag l/d for a wing or airfoil is an important aerodynamic parameter, indeed, it is a direct measure of the aerodynamic efficiency of the wing. if a wing is pitched through a range of angle of attack, l/d first increases, then goes through a maximum, and then decreases. consider an infinite wing with an naca 2412 airfoil. estimate the maximum value of l/d. assume that the reynolds number is 9x10^6.

Answers: 2

continue

Physics, 22.06.2019 12:30, decemberbooker2505

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Answers: 1

continue

You know the right answer?

In the United States, radioactive waste is divided into three main categories based on their activit...