Physics, 24.11.2021 04:20 sassy11111515

01 Fig. 2.1 shows a hammer being used to drive a nail into a piece of wood.
hammer head
nal
wood
Fig. 2.1
The mass of the hammer head is 0.15 kg.
The speed of the hammer head when it hits the nail is 8.0 m/s.
The time for which the hammer head is in contact with the nail is 0.0015 s.
The hammor head stops after hitting the nail.
(a) Calculate the change in momentum of the hammer head.

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 11:30, Gigglygoose4181

1. a camcorder has a power rating of 19 watts. if the output voltage from its battery is 7 volts, what current does it use?answer units 2. a 1.5m wire carries a 6 a current when a potential difference of 57 v is applied. what is the resistance of the wire? yourunits 3. a clothes dryer uses about 2 amps of current from a 240 volt line. how much power does it use? yourunits 4.

Answers: 1

continue

Physics, 22.06.2019 12:10, anaroles04

Light traveling in water, nwater = 1.33, strikes a plastic block at an angle of incidence of 51.4°; part of the beam is reflected and part is refracted. if the index of refraction of the plastic is 2.0, what is the angle made by the reflected and refracted beams?

Answers: 2

continue

Physics, 22.06.2019 16:10, amastriano6192

Ain is , is 's of ? 0.62 0.79 1.27 1.50

Answers: 3

continue

Physics, 22.06.2019 18:10, coryowens44

Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)

Answers: 1

continue

You know the right answer?

01 Fig. 2.1 shows a hammer being used to drive a nail into a piece of wood.
hammer head