Physics, 21.10.2021 01:00 domiyisthom
A wire is joined to points X and Y in the circuit diagram shown.
A diagram of a circuit with a power source on the left. Directly above the power source is a dot labeled X and then a circle with an X in it. The circuit then splits with one path straight back to the power source and the other path has 3 circles with X in them labeled 2, 3, and 4 respectively. There is a point labeled Y between circles 2 and 3.A diagram of a circuit with a power source on the left. Directly above the power source is a dot labeled X and then a circle with an X in it. After the x are 4 different circles on the circuit with Xs in them labeled 1, 2, 3, and 4 respectively. There is a point labeled Y in between circles 2 and 3. There is a branch of the circuit from X to Y.
How does the circuit change when the wire is added?
Answers: 3
Other questions on the subject: Physics
Physics, 22.06.2019 00:20, pooperjooper
Aparticle of mass m is projected with an initial velocity v0 in a direction making an angle α with the horizontal level ground as shown in the figure. the motion of the particle occurs under a uniform gravitational field g pointing downward. (a) write down the lagrangian of the system by using the cartesian coordinates (x, y). (b) is there any cyclic coordinate(s). if so, interpret it (them) physically. (c) find the euler-lagrange equations. find at least one constant of motion. (d) solve the differential equation in part (c) and obtain x and y coordinates of the projectile as a function of time. (e) construct the hamiltonian of the system, h, and write down the hamilton’s equations (canonical equations) of motion.
Answers: 2
Physics, 22.06.2019 02:50, lilybear1700
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
You know the right answer?
A wire is joined to points X and Y in the circuit diagram shown.
A diagram of a circuit with a pow...
Questions in other subjects:
Mathematics, 06.10.2019 12:30
History, 06.10.2019 12:30
