subject
Physics, 26.09.2021 03:30 rileymorrison5836

Find the resultant of the force vectors shown in the figure below. The forces are F, = 7.50 lb, F2 = 2.00 lb, and F3 = 2.00 lb, and the angles are theta 1= 37.0
° and theta 2= 45.0°


Find the resultant of the force vectors shown in the figure below. The forces

are F, = 7.50 lb, F

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 17:00, jordynsmith02
Shelly experiences a backward jolt when the driver starts the school bus. which of the following explains this phenomenon? a. the inertia of shelly b. the inertia of the bus c. the normal force of the seats on shelly d. the net force acting on shelly in a backward direction e. a zero net force acting on shelly
Answers: 1
image
Physics, 21.06.2019 22:00, baileysosmart
Jason and mia are both running in a race. as they approach the finish line, you being the physicist that you are decide to time how long it takes them to reach the end of the race. when you start your stop watch (you can take this as time t = 0 s) you notice that mia is an unknown distance d ahead of jason and both are moving with the same initial velocity v_0. you also notice that jason is accelerating at a constant rate of a_j, while mia is deaccelerating at a constant rate of -a_m. jason and mia meet each other for the first time at time t = t_1. at this time (t = t_1) jason's velocity is two times that of mia's velocity, meaning v_j (t_1) = 2v_m (t_1). a) draw the position vs. time graph describing mia's and jason's motion from time t = 0 to time t = t_1. clearly label your axes and initial conditions on your graph. b) draw the velocity vs. time graph describing mia and jason's motion from time t = 0s to time t = t_1. clearly label your axes and initial conditions on your graph. c) how long from when the stop watch was started at t = 0s did it take mia and jason to meet? express your answer in terms of know quantities v_0, a_m, and a_j. d) when the stop watch started at time t = 0s, how far apart, d, were mia and jason? express your answer in terms of know quantities v_0, a_m, and a_j.
Answers: 1
image
Physics, 22.06.2019 04:50, ineedhelpplz40
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
image
Physics, 22.06.2019 06:30, vaelriacb9300
Suppose you have a box. which of these is not necessarily a true statement regarding the relationship between the force applied to the box, the work done on the box, and the distance the box is moved? a. if the box is not moved, no force is being applied to the box. b. if no force is applied to the box, no work is done on the box. c. if work is done on the box, then a force is applied to the box. d. if work is done on the box, then the box is moved a distance.
Answers: 2
You know the right answer?
Find the resultant of the force vectors shown in the figure below. The forces are F, = 7.50 lb, F2...

Questions in other subjects:

Konu
English, 04.02.2021 23:40
Konu
Social Studies, 04.02.2021 23:40