Specific Latent heat 1. (a) The melting point and boiling point of lead are 327 and 1774 degrees Celsius
and -219 and -183 for Oxygen.
(i) At - 200 °C will the oxygen be a solid, liquid, or gas?
(ii) At 450 °C will the lead be a solid, liquid, or gas?
(b) The graph shown alongside shows how the temperature of a pure substance
changes as it is heated.

This is important. 1. which of the following is an si base unit for measuring length? (2 points) inch gram meter mole 2. which of the following units for distance is an si unit? (2 points) centimeter foot inch yard 3. which of the following tools should a scientist use to measure an object in meters? (2 points) electronic balance pan balance tape measure thermometer

What are two different ways you could find the value of a? explain these methods.

The inside surface of a cylindrical-shaped cave of inner diameter 1.0 m is continuously covered with a very thin layer of water. the cave is very long and it is open on both ends. the water on the cave surface is at a constant temperature of 15.5 °c. the cave is constantly exposed to wind such that 15.5 °c air flows through the cave at 4.5 m/s. the kinematic viscosity of the air is 14.66 x 10-6 m2/s and the molecular diffusion coefficient of water vapor in the air is 0.239 x 10-4 m2/s. because the cave diameter is so large, the flow of wind down the length of the cave, in the x direction, can be treated like it is external flow and the cave surface can be approximated as flat where appropriate. calculate the x value, in a) the transition to turbulent flow occurs at rex meters, where the air flow transitions from laminar to turbulent along the inside surface of the cave b) calculate the x value, in meters, where the bulk steady state concentration of water vapor in the air flowing in the cave is 10% of the saturation concentration. assume the air at the surface of the water layer is 100% saturated with water vapor. assume the wind entering the cave contained no moisture before it entered the cave. take into account the transition from laminar to turbulent flow when solving part b