Physics, 26.08.2021 17:40 kaylakk5

How many milliliters are in 1 liter?

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 06:30, bluevibe

2kg of refrigerant 134a undergoes a polytropic process in a piston-cylinder assembly from an initial state of saturated vapor at 2 bar to a final state of 12 bar, 80 degree c. a)determine the work for the process in kj. b)sketch the process on a p-v diagram.

Answers: 2

continue

Physics, 23.06.2019 01:30, chafinh1811

Six pendulums of mass mand length las shown are released from rest at the same angle theta from vertical. rank the pendulums according to the numberof complete cycles of motion each pendulum goes through perminute. a. l= 1m m=2kg b. l= 4m m=1 kg c. l= 2 m m= 2 kg d. l= 1 m m= 4 kg e. l= 2 m m = 4 kg f. l= 4m m = 4kg

Answers: 3

continue

Physics, 23.06.2019 05:00, heyitshenna96

Which of hubble’s discovery support the big bang theory

Answers: 1

continue

Physics, 23.06.2019 07:00, hockejoh000

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?