subject
Physics, 08.06.2021 22:30 bob4059

Help asap Part D When writing a scientific paper, you want to find the most credible sources. Some websites present things as evidence that have not been proven scientifically. You must be able to identify reliable sites so the data in your paper is credible. Only use sources that end in .edu (school and college websites) and .gov (government websites). Only use .org or .com sites if they are reliable. Sometimes students, not scientists, write content for .edu websites. Because the content might not be checked by scientists, read any .edu website carefully to determine whether it is reliable. When you review a source, ask yourself these questions: Who authored the document? Is this person a scientific expert in weather and climate? What is the purpose of the document? Does the article state opinions or does it rely on facts that can be proven by evidence? When was the document written? Do other credible sources support the statements in this document? Write down two to three credible sources you will use to find information for your research paper. They can be books, magazines, websites, or other sources. For each source you find, write down one to two sentences explaining how the source will help you. Show how you will cite each source in a works cited page at the end of your paper using MLA (Modern Language Association) citation methods. Font Sizes Characters used: 0 / 15000

Part E In a separate location, take notes from the sources you have identified. This will take place over two or more days. While taking notes, consider using these reading strategies. From your notes, select one piece of evidence describing a climate similarity or difference that you discovered between these two cities. Write it in the space provided.

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 16:20, jmackenzie7
How does a circuit breaker protect a refrigerator? a. when the current is too high, a metal strip in the fuse melts and opens the circuit. b. when the resistance is too high , a re-settable which opens a circuit c. when the current is too high , a re-settable switch opens the circuit d. when the resistance is too high a metal strip in the fuse melts and opens the circuit
Answers: 2
image
Physics, 22.06.2019 19:30, FireFlight
Point charges q1=+2.00μc and q2=−2.00μc are placed at adjacent corners of a square for which the length of each side is 1.50 cm . point a is at the center of the square, and point b is at the empty corner closest to q2. take the electric potential to be zero at a distance far from both charges. part a what is the electric potential at point a due to q1 and q2? express your answer with the appropriate units.
Answers: 2
image
Physics, 23.06.2019 04:00, byron17
A15 ohm resistor and a 25 ohm resistor are connected in a series to a 60 volt battery. what is the power used by each device
Answers: 3
image
Physics, 23.06.2019 05:30, efraruiz02
Oxygen gas enters well-insulated diffuser at 25 lbf/in.2, 420r, with a velocity of 860 ft/s through a flow area of 1.6 in.^2. at the exit, the flow area is 12 times the inlet area, and the velocity is 19 ft/s. the potential energy change from inlet to exit is negligible. assuming ideal gas behavior for the oxygen and steady-state operation of the diffuser, determine the following: (a) the exit temperature, in r(b) the exit pressure, in lbf/in.^2 (c) the mass flow rate, in lb/s
Answers: 3
You know the right answer?
Help asap Part D When writing a scientific paper, you want to find the most credible sources. Some...

Questions in other subjects: