Vectors B and C are shown in the coordinate plane. Vector F is given by 7 = + c
у
33°
5.6
22
4.8
too
T
What is the approximate magnitude of vector ?
O 8.0
O 19
O 10
16
O 13

The extremely high temperatures needed to trigger nuclear fusion are proposed to be generated by laser irradiating a spherical pellet of deuterium and tritium fuel of diameter 1.8 mm. (a) determine the maximum fuel temperature that can be achieved by irradiating the pellet with 200 lasers, each producing a power of 550 w. the pellet has an absorptivity 0.3 and emissivity 0.8.

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.