The strength of an electric field at a specific location is indicated by "blank" The difference in blank between two locations is known as "blank", or voltage.

The potential energy an electric charge has due to its location in an electric field is "blank"

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

blue light is scattered in different directions by the tiny molecules of air. blue is scattered more than other colours because it has a shorter distance to travel which results in smaller waves. this is why we see a blue sky most of the time.

the answer is 100. i just did this lesson and got a 100% on it. : )

-fishtank

explanation:

to push or pull an object in a certain direction is known as force. a force in moving an object from one place to another.

force depends on the mass of an object. so, more is the mass of an object more will be the force required to move the object.

thus, we can conclude that the use of force to move an object is push or pull.