subject
Physics, 27.05.2021 01:00 bestballer7095

How can modeling crustal deformation of Earth by plate tectonics be used to analyze and hypothesize the causes of earthquakes? Starter:
My scientific explanation is:

ansver
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 16:00, amoakoh800003
As shown in fig. p3.64, a closed, rigid tank fitted with a fine-wire electric resistor is filled with refrigerant 22, initially at 2108c, a quality of 80%, and a volume of 0.01 m3. a 12-volt battery provides a 5-amp current to the resistor for 5 minutes. if the final temperature of the refrigerant is 408c, determine the heat transfer, in kj, from the refrigerant.
Answers: 1
image
Physics, 22.06.2019 01:10, caguil00
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
image
Physics, 22.06.2019 02:20, Hellokittyjam35
Which changes of state do the labels represent? a: b: c:
Answers: 1
image
Physics, 22.06.2019 10:50, afonseca73
Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.
Answers: 3
You know the right answer?
How can modeling crustal deformation of Earth by plate tectonics be used to analyze and hypothesize...

Questions in other subjects: