subject
Physics, 08.05.2021 01:50 feeandra

PLEASE OM When describing image formation for plane mirrors, what is an important rule to remember about light rays? A. The angle when it leaves is the same as the angle when it hits.
B. The angle is smaller in the medium that has the lower index of
refraction
C. The angle when it leaves is larger than the angle when it hits.
D. The angle is smaller in the medium that has the higher index of
refraction

ansver
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
image
Physics, 22.06.2019 09:40, goofy44
Aturntable a is built into a stage for use in a theatrical production. it is observed during a rehearsal that a trunk b starts to slide on the turntable 10 s after the turntable begins to rotate. knowing that the trunk undergoes a constant tangential acceleration of 0.31 m/s2, determine the coefficient of static friction between the trunk and the turntable.
Answers: 3
image
Physics, 23.06.2019 00:50, anikakurup0
Which of the following examples illustrates static friction? a box sits stationary on a ramp. a ball rolling on the lawn eventually comes to rest. a car rounds a curve on a road. a fish swims upstream.
Answers: 1
image
Physics, 23.06.2019 02:00, molly7392
Which statement describes the formation of our sun? a disk formed of long trails of stars coiled into a spiral. it formed an elliptical flattened disk. heat and gases contracted within a nebula. gravity pushed stars away from a center core.
Answers: 1
You know the right answer?
PLEASE OM When describing image formation for plane mirrors, what is an important rule to remember a...

Questions in other subjects:

Konu
English, 07.04.2020 19:42