Now, select the Slits simulation at the bottom of the screen, and Light (red) for the type of wave, as before. Also, make sure there is a barrier with one slit, and use the tape measure as well as the slider bar below the slit to place it roughly 1290 nm away from the light source. Adjust the slit width to 300 nm. Finally, select the start button at the source location to begin producing the waves. Which statement best describes how the intensity of the wave depends on position along the screen?
Answers: 1
Other questions on the subject: Physics
Physics, 22.06.2019 13:40, crayons18
An ideal otto cycle has a compression ratio of 10.5, takes in air at 90 kpa and 40°c, and is repeated 2500 times per minute. using constant specific heats at room temperature, determine the thermal efficiency of this cycle and the rate of heat input if the cycle is to produce 90 kw of power.
Answers: 2
You know the right answer?
Now, select the Slits simulation at the bottom of the screen, and Light (red) for the type of wave,...
Questions in other subjects:
