Physics, 04.05.2021 14:00 samiller30

A skydiver jumps from a stationary helicopter and reaches a steady vertical speed. She then opens her parachute.
Which statement about the falling skydiver is correct?

A As her parachute opens, her acceleration is upwards.
B As she falls at a steady speed with her parachute open, her weight is zero.
C When she accelerates, the resultant force on her is zero.
D When she falls at a steady speed, air resistance is zero.

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 21:40, sannai0415

Since the investigative question has two variables, you need to focus on each one separately. thinking only about the first part of the question, mass, what might be a hypothesis that would illustrate the relationship between mass and kinetic energy? use the format of "if…then…because…” when writing your hypothesis.

Answers: 1

continue

Physics, 21.06.2019 23:30, ladawnrowles005

Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?

Answers: 3

continue

Physics, 22.06.2019 01:10, caguil00

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Answers: 3

continue

Physics, 22.06.2019 11:20, cjd1214812148

The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)

Answers: 3

continue

You know the right answer?

A skydiver jumps from a stationary helicopter and reaches a steady vertical speed. She then opens...