C. Consumers in the reef can be further classified as filter feeders, or organisms that eat plankton by filtering water; grazers, or organisms that feed on organisms that don't move; and predators, or
organisms that eat other animals. List at least one example of each.

Filter feeders:
Grazers:
Predators:

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 790 n/m. it is initially at rest on an inclined plane that is at an angle of 28 degrees with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is k = 0.14. in the initial position, where the spring is compressed by a distance of a = 0.18 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. b) if the spring pushes the block up the incline, what distance, l, in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.

Search coils and credit cards. one practical way to measure magnetic field strength uses a small, closely wound coil called a search coil. the coil is initially held with its plane perpendicular to a magnetic field. the coil is then either quickly rotated a quarter-turn about a diameter or quickly pulled out of the field. (a) derive the equation relating the total charge q that flows through a search coil to the magnetic-field magnitude b. the search coil has n turns, each with area a, and the flux through the coil is decreased from its initial maximum value to zero in a time ∆t. the resistance of the coil is r, and the total charge is q = i∆t, where i is the average current induced by the change in flux. (b) in a credit card reader, the magnetic strip on the back of a credit card is rapidly “swiped” past a coil within the reader. explain, using the same ideas that underlie the operation of a search coil, how the reader can decode the information stored in the pattern of magnetization on the strip. (c) is it necessary that the credit card be “swiped” through the reader at exactly the right speed? why or why not?