Physics, 18.09.2019 22:30 xmanavongrove55

match the simple machine with the correct definition.

- class lever

plane
- class lever
and axle

- class lever
a. any slanting, flat surface
b. a rigid bar that rotates about a pivot called a fulcrum
c. an inclined plane wrapped around a cylinder
d. load is in the middle
e. two inclined planes placed back to back
f. a wheel turning around an axle inserted through its center
g. effort is in the middle
h. a circular lever that consists of a grooved wheel rotating about a hub
i. fulcrum is between the effort and load

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 23:20, nathalyviruete

Imagine you had to physically add electrons, one at a time, to a previously neutral conductor. you add one electron very easily, but the second electron requires more work. in your initial post to the discussion, explain why this is. also, what happens to the work needed to add the third, fourth, fifth, and subsequent electrons

Answers: 1

continue

Physics, 22.06.2019 11:30, Gigglygoose4181

1. a camcorder has a power rating of 19 watts. if the output voltage from its battery is 7 volts, what current does it use?answer units 2. a 1.5m wire carries a 6 a current when a potential difference of 57 v is applied. what is the resistance of the wire? yourunits 3. a clothes dryer uses about 2 amps of current from a 240 volt line. how much power does it use? yourunits 4.

Answers: 1

continue

Physics, 22.06.2019 12:30, lmolder1329

Consider a 1000 w iron whose base plate is made of 0.5 cm thick aluminum alloy 2024-t6 (ρ = 2770 kg/m3 and cp = 875 j/kg°c). the base plate has a surface area of 0.03 m2. initially, the iron is in thermal equilibrium with the ambient air at 22°c. assuming 90% of the heat generated in the resistance wires is transferred to the plate, determine the minimum time needed for the plate temperature to reach 200°c.

Answers: 1

continue

Physics, 22.06.2019 23:30, queenbroookk

Newton's law of cooling states that the rate of change in the temperature t(t) of a body is proportional to the difference between the temperature of the medium m(t) and the temperature of the body. that is, startfraction dt over dt endfraction equals upper k left bracket upper m left parenthesis t right parenthesis minus upper t left parenthesis t right parenthesis right bracket , where k is a constant. let kequals0.04 left parenthesis min right parenthesis superscript negative 1 and the temperature of the medium be constant, m(t) font size decreased by 3 equivalent font size decreased by 3 294 kelvins. if the body is initially at 369 kelvins, use euler's method with hequals0.1 min to approximate the temperature of the body after (a) 30 minutes and (b) 60 minutes.

Answers: 2

continue

You know the right answer?

match the simple machine with the correct definition.

- class lever
...