subject
Physics, 13.04.2021 16:20 raffigi

HELPP You exert 500N of force on a wall but it does not move. You exert 5N of force on a marble and it moves 10 meters. In which situation has more work been done?​

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, markyyy53
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
image
Physics, 21.06.2019 23:30, kaytonleeb
The velocity of car is 80.0 miles per hour. what is the velocity of car in meters per second? (1 km -0.621 miles) m/s
Answers: 2
image
Physics, 22.06.2019 22:30, allysoftball4878
Use the illustration to describe how the electromagnetic spectrum changes as its frequency moves from radio waves to higher energy gamma waves in terms of wavelength and amplitude.
Answers: 1
image
Physics, 23.06.2019 06:30, IkarosSakurai
Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?
Answers: 2
You know the right answer?
HELPP You exert 500N of force on a wall but it does not move. You exert 5N of force on a marble and...

Questions in other subjects:

Konu
Social Studies, 28.08.2020 05:01
Konu
Mathematics, 28.08.2020 05:01
Konu
Chemistry, 28.08.2020 05:01
Konu
Mathematics, 28.08.2020 05:01
Konu
English, 28.08.2020 05:01