subject
Physics, 31.03.2021 05:40 rilee3344

10. Which of the following is accurate when discussing specific heat? O A Soeric heat values for liquids will never vary for different ranges of temperature,
B. Specfic heat values for solids will never vary for different ranges of temperature.
C. The spect chest of a gas can be measured at constant pressure.
D. The specific heat of a gas can be measured at constant volume only

ansver
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 23:10, tonytashaqua
What happens in a global convection cell
Answers: 1
image
Physics, 22.06.2019 05:20, cwsmith8026
Very large accelerations can injure the body, especially if they last for a considerable length of time. one model used to gauge the likelihood of injury is the severity index ( ), defined as =/ . in the expression, is the duration of the accleration, but is not equal to the acceleration. rather, is a dimensionless constant that = the number of multiples of that the acceleration is equal to. in one set of studies of rear-end collisions, a person's velocity increases by 13.7 km/h with an acceleration of 36.0 m/s2 . let the + direction point in the direction the car is traveling. what is the severity index for the collision?
Answers: 1
image
Physics, 22.06.2019 15:00, hma9153
Amoving company collects data about couches they move and displays the data in a table. the force along the ramp, the angle of the ramp, and the height the couch is raised to are shown. which statements correctly compare the work done to move the couches? check all that apply. the same amount of work is done for couches 1 and 3. the same amount of work is done for couches 2 and 3. the work for couch 1 is greater than the work for couch 2. the work for couch 2 is less than the work for couch 3. the work for couch 3 is greater than the work for couch 1. the work for couch 2 is greater than the work for couch 1.
Answers: 1
image
Physics, 22.06.2019 16:50, lizzepacheco
Acommercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at -35°c by rejecting waste heat to cooling water that enters the condenser at 18°c at a rate of 0.25 kg/s and leaves at 26°c. the refrigerant enters the condenser at 1.2 mpa and 50°c. if the compressor consumes 3.3 kw of power, determine (a) the mass flow rate of the refrigerant, (b) the refrigeration load, (c) the cop, and (d) the minimum power input to the compressor for the same refrigeration load.
Answers: 2
You know the right answer?
10. Which of the following is accurate when discussing specific heat? O A Soeric heat values for li...

Questions in other subjects: