The 60-mm-diameter shaft is made of 6061-t6 aluminum having an allowable shear stress of τallow = 80 mpa. determine the maximum allowable torque t . also, find the corresponding angle of twist of disk a relative to disk c .

freezing

deposition

condensation

explanation;

melting also called fusion is the process where solid becomes liquid, sublimation is the process where solid becomes gaseous without first changing to liquid, deposition involves change from gaseous to solid state, freezing involves change from liquid to solid, boiling or evaporation involves change of liquid to gaseous state, while condensation is the change from gaseous state to liquid state.

endothermic reactions involves absorption of heat from the surroundings or the environment while exothermic reactions involves loss of heat energy to the surroundings.

in this case, sublimation, evaporation and melting are endothermic reactions (gain energy from the environment) while, freezing, deposition and condensation are exothermic (loss of energy to the surroundings) reactions.

the design of a ski jumping suit involves a trade-off between giving the skiers lift to get higher jumps and ensuring the skier does not face a lot of drag before the jump itself. an expansive suit may to lift the skier higher, but at the same time, it will also increase the air resistance. higher air resistance as the skier goes down the slope limits the speed of the jump. a big suit also increases the risk of losing balance or control, especially if there's a strong gust of wind. while technologically enhanced suits a lot, clothing is not the only factor in a ski jumper’s success. gathering speed while skiing down the slope, ensuring good speed on the ramp, and maintaining good body posture and form in the air all contribute to a ski jumper's success.