Physics, 23.03.2021 01:40 andrewjsoto

DENSITY OF SOLIDS Section III: Analysis and Discussion
Use your answers from questions 6–8 as the basis for the third section of your lab report. This section provides your reader with your interpretation of the data set. You will also give an example of any calculations or formulas you used to analyze your data. Also, if you want to include any graphs that you made and interpret them for the reader, you can.
If you do construct graphs, your Student Guide includes information on which graphs to construct. Graphs should have the following:

Appropriate titles
Appropriate labels for each axis
Appropriate scales for each axis
Correct units for the data

Complete a rough sketch of each graph. Explain in one or two sentences what trend the reader should observe in each of your graphs.
Mention any problems, unusual or unexpected data, or other factors with the experiment here, and suggest possible causes. This section can be somewhat subjective, unlike Section II, because you are free to include your personal interpretations or even speculation if it adds constructive, reasonable insight to the discussion.

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 16:30, minnie7760

Aball bearing at 220.0 °c is dropped into a cup containing 250.0 g of water at 20.0 °c. the water and ball bearing come to a temperature of 30.0 °c. what is the heat capacity of the ball bearing in j/°c? (hint: how are the algebraic signs of q related for the ball bearing and the water? )

Answers: 1

continue

Physics, 21.06.2019 20:00, mystaxkkks

You notice a very one-dimensional-thinking snail crawling along one rail of a railroad track. naturally, you remove it to a safer place. but before you do, you observe it as it moves from position xi = -92.9 cm to position xf = -64.9 cm along the rail, as measured from a point where one rail abuts the next. what is the snail\'s displacement δx in centimeters?

Answers: 1

continue

Physics, 22.06.2019 13:40, youngbeauty17

Awind turbine is rotating counterclockwise at 0.5 rev/s and slows to a stop in 10 s. its blades are 20 m in length. (a) what is the angular acceleration of the turbine? (b) what is the centripetal acceleration of the tip of the blades at t=0s? (c) what is the magnitude and direction of the total linear acceleration of the tip of the blades at t=0s?

Answers: 1

continue

Physics, 22.06.2019 21:30, mxrvin4977

Ineed this now one scientist feels that the changes in global climatic patterns may be good for the health of the biosphere. another scientist feels that sharp changes in climatic patterns could result in the extinction of the biosphere. which of these is the most likely reason the two scientists gave conflicting opinions on the impact of changes in the global climatic pattern? they do not have enough knowledge on the topic. they did not discuss the issue among themselves. they believe conflicting opinion strengthens science. they study different areas of science and have different scientific focuses.

Answers: 1

continue

You know the right answer?

DENSITY OF SOLIDS Section III: Analysis and Discussion
Use your answers from questions 6–8 as...