יז Two charges are located on the positive x-axis of a coordinate system. Charge g1
= 6 C, and it is 6cm from the origin. Charge q2 = -3.0 C, and it is 12 cm from the
origin. How large is the electric force exerted by these two charges on a third
charge, q3 = 5.0 C, located at the origin? (k = 9 x 109 Nm/C)
2
8.43x1013 N
6.56x1013 N
-6.56x1013 N
9.3 x 1012 N

Derive the formula 2as=v² -u² where the formula have have usual meanings

Hunter is in lab. he clears a spot on his lab bench to start working. he also puts his lab coat and goggles on. he then identifies where all of the safety equipment is. he notices his station is next to the fume hood, which ventilates the chemicals stored there. the noise of the fume hood was bothersome, so hunter turned it off. which could be an error in his set-up? he should not turn off the fume hood.  he should wait to put on his coat until after the directions are given.  he should wait to put on his goggles until after the directions are given.  he should not sit next to the fume hood. 

Atension test was conducted on a specimen of aisi 1020 hot-rolled steel having an initialdiameter of 9.11 mm. representative test data are given in table1in the form of force and engineering strain. for strain the extensometer gage length was li= 50.8 mm. in addition, minimumdiameters were measuredmanually with a micrometer in the necked region at several points during the test. after fracture, thebroken halves were reassembled, and the following measurements were made: (1) marks originally 25.4 mm apart and on opposite sides of the necked regionwere 38.6 mm apart due to the lengthwise stretching in the specimen; (2) similar marks originally 50.8 mm apart were 70.9 mmapart; (3) the final minimum diameter in the necked region was 5.28 mma) determine the following material properties: elastic modulus, 0.2% offset yield strength, ultimate tensile strength, percent elongation, and percent reduction in area. b) assume that the test was interrupted upon reaching a strain u = 0.007, and the specimen unloaded to zero force. estimate the elastic strain recovered and the plastic strain remaining. also, what would the new length of the original 50.8 mm gage section. hint: might save time/effort to use excel, mathcad, matlab, etc. to solve part a)table1 data and analysis for a tension test on aisi 1020 hot-rolled steeltest dataforce (p, kn)1. 0.002. 6.673. 13.344. 19.135. 17.796. 17.217. 17.538. 17.449. 17.2110. 20.7711. 24.2512. 25.7113. 25.7514. 25.0415. 23.4916. 21.3517. 18.9018. 17.39engr. strain (ε)1. 02. 0.00053. 0.00104. 0.00155. 0.00236. 0.00317. 0.00508. 0.00709. 0.010010. 0.049011. 0.125012. 0.218013. 0.234014. 0.306015. 0.330016. 0.348017. 0.360018. 03660diameter (d, mm)1. 9.112. 9.113. 9.114. 9.115. 9.116. 9.117. 9.118. 9.119. 9.1110. 8.8911. 8.8912. 8.2613. 8.2614. 7.6215. 6.9916. 6.3517. 5.7218. 5.28