subject
Physics, 18.03.2021 01:00 WhiteWinterRose

Select all that apply. PLZ Which of the following do not illustrate a complete circuit?

D
C
A
B


Select all that apply. PLZ

Which of the following do not illustrate a complete circuit?
D
C
A
B

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:10, joejoefofana
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
image
Physics, 22.06.2019 19:30, VonneB1684
Which describes increasing the efficiency of energy resource
Answers: 1
image
Physics, 22.06.2019 21:00, estebencampos69
Aflask with vinegar in it has a mass of 160 grams. a balloon with baking soda in it has a mass of 40 grams. the balloon is attached to the flask to seal the opening and the vinegar and baking soda mixes. the balloon inflates to a large volume. what will the total mass of the balloon and flask be after the balloon inflates? explain. a) less than 200 grams because the solid baking soda disappears. b) 200 grams, because all the atoms remain in the balloon or flask. c) more than 200 grams because the size of the balloon is so much larger. d) less than 200 grams because gases such as the one in the balloon are lighter than solids and liquids.
Answers: 1
image
Physics, 22.06.2019 23:00, Neko1kat
Which type of reaction is shown in this energy diagram? energy products activation energy reactants time o a. endothermic, because energy is released to the surroundings o b. exothermic, because energy is absorbed from the surroundings o c. exothermic, because energy is released to the surroundings o d. endothermic, because energy is absorbed from the surroundings
Answers: 1
You know the right answer?
Select all that apply. PLZ Which of the following do not illustrate a complete circuit?

...

Questions in other subjects:

Konu
Chemistry, 01.04.2020 02:55