Physics, 27.02.2021 15:50 whosdarrin9396

What does transverse wave mean

Answers: 3

Show answers

Answers

Transverse wave, motion in which all points on a wave oscillate along paths at right angles to the direction of the wave's advance. Surface ripples on water, seismic S (secondary) waves, and electromagnetic (e.g., radio and light) waves are examples of transverse waves.

Answer from: triciamarler

Explanation:

Examples of transverse waves include:

ripples on the surface of water.

vibrations in a guitar string.

a Mexican wave in a sports stadium.

electromagnetic waves – eg light waves, microwaves, radio waves.

seismic S-waves.

Answer from: Quest

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

Answer from: Quest

im guessing the west of station b

Other questions on the subject: Physics

Physics, 21.06.2019 16:10, dooboose15

Alow cost, low earth orbit (leo) satellite is to be fabricated at a university, for subsequent launch by rocket. what are the constraints and objectives for selection of a material suitable for the satellite bus (i. e. the structure)? explain each in brief. (15 marks) b)suggest sources of data which could support the selection of materials for applications in space. (5 marks) c) set weights for the objectives listed in (2a) using the digital logic method. (5 marks)

Answers: 1

continue

Physics, 21.06.2019 22:00, homework2358

There is a theory that indicates that dinosaurs became extinct when about 65 million years ago, a large asteroid hit the earth surface. dust caused by this collision blocked the sunlight reaching the earth's surface and many forms of life became extinct due to the cold. fearing this threat, how large the radius of an asteroid should you be looking for if the dangerous asteroid size is approximately the same as the one that killed the dinosaurs? available data suggests that about 18% of that asteroid's mass ended up as a dust spread evenly over earth after eventually settling out of the upper atmosphere. about 0.0180 g/cm^2 of dust, which is chemically different than the earth's rock, covered the earth's surface. typical asteroids have a density of about 1.9 g/cm^3. now that we know the size of the asteroid, how much energy was released during impact, assuming all of it was just the kinetic energy of the asteroid right before the impact?

Answers: 1

continue

Physics, 22.06.2019 12:30, dee2970

Write a full page that sumerizes thermodynamics it’s from the website visionlearnig

Answers: 1

continue

Physics, 22.06.2019 16:30, skiddymark3ox93za

Iron is a transition metal with multiple oxidation numbers. (answer the following) a. what is the iron (ii) ion? how does it differ from the iron (iii) ion? b. if iron were to bond with oxygen, predict the formula for each oxidation number of iron. c. how would each formula be named?

Answers: 2

continue

You know the right answer?

What does transverse wave mean...