Physics, 09.02.2021 04:20 ramosramos142

A car is sitting still. It accelerates to a constant speed then it decelerates again to zero speed. While the car is accelerating how do the directions of the angular acceleration and angular velocity of one of the wheels compare

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 13:30, germanie123

Plzz plzzz i'll give you 25 pointshow does the water cycle influence weather in your area? use complete sentences and a specific example from your experience.

Answers: 3

continue

Physics, 21.06.2019 17:10, seby77L

Aspecial electronic sensor is embedded in the seat of a car that takes riders around a circular loop-the-loop ride at an amusement park. the sensor measures the magnitude of the normal force that the seat exerts on a rider. the loop-the-loop ride is in the vertical plane and its radius is 23 m. sitting on the seat before the ride starts, a rider is level and stationary, and the electronic sensor reads 740 n. at the top of the loop, the rider is upside down and moving, and the sensor reads 370 n. what is the speed of the rider at the top of the loop?

Answers: 1

continue

Physics, 22.06.2019 16:40, jcblake

Beryl states that insulation with the smallest possible thermal conductivity is best to keep a house warm in winter, but worst for keeping a house cool in summer. sapphire insists the reverse is true: low thermal conductivity is good in the summer, but bad in the winter. which one, if either is correct? a. beryl, because low thermal conductivity results in low heat transfer. b. beryl, because low thermal conductivity results in high heat transfer. d. sapphire, because low thermal conductivity results in high heat transfer. e. neither, because low heat transfer is desirable both in summer and in winter.

Answers: 2

continue

Physics, 22.06.2019 18:00, maren17

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)

Answers: 3

continue

You know the right answer?

A car is sitting still. It accelerates to a constant speed then it decelerates again to zero speed....