Physics, 30.01.2021 23:10 chaundreascott743

In an attempt to deliver a parcel on time, the dispatch rider had to ride 10 kilometers 15 degrees south east ,he then rode 11 kilometers 30 degrees north east and then takes a shortcut at 22 kilometers Find the rider's displacement

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 19:20, itzia00

How would you place two electrons on a sphere of radius r so that the electrostatic potential energy is minimized. how would you place three electrons to solve the same problem.

Answers: 1

continue

Physics, 21.06.2019 22:00, jby

Atank holds 1000 gallons of water, which drains from the bottom of the tank in half an hour. the values in the table show the volume v of water remaining in the tank (in gallons) after t minutes. t(min) 5 10 15 20 25 30v(gal) 694 444 250 111 28 0(a) if p is the point (15, 250) on the graph of v, find the slopes of the secant lines pq when q is the point on the graph with t = 5, 10, 20, 25, and 30.(b) estimate the slope of the tangent line at p by averaging the slopes of two secant lines.(c) use a graph of the function to estimate the slope of the tangent line at p. (this slope represents the rate at which the water is flowing from the tank after 15 minutes.)show all steps.

Answers: 2

continue

Physics, 21.06.2019 23:00, ImBADatmath8743

Asubmarine has a "crush depth" (that is, the depth at which water pressure will crush the submarine) of 250 m. what is the approximate pressure (water plus atmospheric) at this depth? (recall that the density of seawater is 1025 kg/m3, g = 9.81 m/s2, and 1 kg/(ms2) = 1 pa = 9.8692 10-6 atm.) a. 34.8 atm b. 24.8 atm c. 25.8 atm d. 7.8 atm

Answers: 2

continue

Physics, 22.06.2019 02:50, lilybear1700

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

continue

You know the right answer?

In an attempt to deliver a parcel on time, the dispatch rider had to ride 10 kilometers 15 degrees s...