subject
Physics, 27.01.2021 01:00 justinslusser51111

The hummer H2 truck has a mass of 2903kg. It slows down uniformly to a stop. It's acceleration is -2.1 m/s. How much force was required for the truck to slow down to a stop?

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 02:50, lilybear1700
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
image
Physics, 22.06.2019 07:20, Nadi4753
Samir watches a 100-minute movie on his spaceship. maria's spaceshipe flies in the same direction as samir's spaceship but she observes his move to last 125 minutes and his spaceship to be 40 m long. how long does samir observe his own spaceship to be? according to an observer on earth, planet x is stationary. maria and samir depart earth on their spaceships at the same time, each flying at 0.5c. maria flies toward planet x and samir flies in the opposite direction. according to maria, her voyage to planet x takes 9 years. how many years does marias voyage take according to samir?
Answers: 3
image
Physics, 22.06.2019 07:30, alejandro1102
The charge on a charged sphere is: a)concentrated at its centerb)distributed uniformly throughout its volumec)clustered on its centerd)distributed uniformly over its surface
Answers: 1
image
Physics, 22.06.2019 12:00, angelamirga332
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
You know the right answer?
The hummer H2 truck has a mass of 2903kg. It slows down uniformly to a stop. It's acceleration is -2...

Questions in other subjects:

Konu
Mathematics, 29.05.2020 20:01