Physics, 26.01.2021 18:00 lerasteidl

Velocity is measured in units of ? choose all that apply? m/s^2, km/h. s, km/h, miles/minute, km/days, and mph

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 04:50, jojoblue2004

Unpolarized light whose intensity is 1.19 w/ is incident on a polarizer. (a) what is the intensity of the light leaving the polarizer? (b) if the analyzer is set at an angle of = 41.0∘ with respect to the polarizer, what is the intensity of the light that reaches the photocell?

Answers: 1

continue

Physics, 22.06.2019 08:40, kayleewoodard

Apulley system is used to lift a 2,000 newton engine up a distance of 3 meters. the operator must apply a force of 250 newtons to the chain of the pulley system to lift the motor. to lift the engine 3 meters, the operator must pull a total of 30 meters of chain through the pulley system. what is the value of di?

Answers: 1

continue

Physics, 22.06.2019 16:40, Crxymia

Aparticle's position is given by x = 3.00 - 9.00t + 3t2, in which x is in meters and t is in seconds. (a) what is its velocity at t = 1 s? (b) is it moving in the positive or negative direction of x just then? (c) what is its speed just then? (d) is the speed increasing or decreasing just then? (try answering the next two questions without further calculation.) (e) is there ever an instant when the velocity is zero? if so, give the time t; if not, answer "0". (f) is there a time after t = 3 s when the particle is moving in the negative direction of x? if so, give the time t; if not, answer "0".

Answers: 3

continue

Physics, 22.06.2019 18:00, maren17

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)

Answers: 3

continue

You know the right answer?

Velocity is measured in units of ? choose all that apply? m/s^2, km/h. s, km/h, miles/minute, km/da...