subject
Physics, 18.01.2021 14:00 rederisbetter9379

Sit down with your feet on the ground on a chair that rotates. Lift one of your legs such that it is unbent (straightened out). Using the other leg, begin to rotate yourself by pushing on the ground. Stop using your leg to push the ground but allow the chair to rotate. From the origin where you began, sketch the angle, angular velocity, and angular acceleration of your leg as a function of time in the form of three separate graphs. Estimate the magnitudes of these quantities.

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:10, edjiejwi
Agas is contained in a vertical, frictionless piston–cylinder device. the piston has a mass of 3.2 kg and a cross-sectional area of 35 cm2. a compressed spring above the piston exerts a force of 190 n on the piston. if the atmospheric pressure is 95 kpa, determine the pressure inside the cylinder.
Answers: 3
image
Physics, 22.06.2019 00:40, naomicervero
The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.
Answers: 1
image
Physics, 22.06.2019 04:20, gonzalesalexiaouv1bg
When considering gravity acceleration and the force of acceleration, what must be true? a. the direction of acceleration must be perpendicular to the direction of the force. b. the direction of the force and the direction of acceleration must be the same as each other. c. the direction of the force and the direction of acceleration must be opposite of each other. d. the mass of the body must be the same as the acceleration of the body.
Answers: 1
image
Physics, 22.06.2019 12:30, decemberbooker2505
Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question
Answers: 1
You know the right answer?
Sit down with your feet on the ground on a chair that rotates. Lift one of your legs such that it is...

Questions in other subjects:

Konu
Geography, 20.07.2019 17:30