Physics, 13.01.2021 01:50 michellectucker1982
Which pair of structures would provide a positive identification of a plant cell under a microscope?
a. plasma membrane, large central vacuole
b. cell wall, mitochondria
c. ribosomes, chloroplasts
d. cell wall, chloroplast
Answers: 3
Physics, 22.06.2019 02:50, lilybear1700
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
Physics, 22.06.2019 03:30, natu2072
Using a wheel and axle, a farmer is trying to lift a bucket of water from the bottom of a well. the larger wheel has a radius of 40 cm compared to the axle that has a radius of 10 cm. if a bucket of water is 50 n, then how much effort is required to raise it? 12.5 n 200 n 2 n 500 n
Answers: 1
Physics, 22.06.2019 04:00, binodkharal2048
Which configuration would produce an electric current? a) rotate a coil of copper wire between two magnets. b) connect a wire between a copper and zinc strip sitting in a beaker of water. c) connect a wire to the (+) positive end of a battery and the other end to a light bulb. d) connect a wire to the negative end of a battery and the other end to a light bulb.
Answers: 2
Which pair of structures would provide a positive identification of a plant cell under a microscope?...
Mathematics, 23.11.2019 04:31
Mathematics, 23.11.2019 04:31
Mathematics, 23.11.2019 04:31