subject
Physics, 15.12.2020 20:00 AbhiramAkella

Which is one factor that contributes to the formation of polar, temperate, and tropical zones?

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 17:20, jvanegas6797
Research the neutrino using the internet and report your findings. in a nuclear decay, the nucleus of an atom splits apart. larger particles can be detected and their masses and velocities can be recorded. explain how the existence and properties of the neutrino could be predicted using the conservation laws.
Answers: 3
image
Physics, 21.06.2019 22:00, markyyy53
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
image
Physics, 22.06.2019 05:10, zionnahl
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
image
Physics, 22.06.2019 05:50, kamrulh278
Acylinder with a movable piston contains 11.7 moles of a monatomic ideal gas at a pressure of 1.32×10^5 pa. the gas is initially at a temperature of 300 k. an electric heater adds 43200 j of energy into the gas while the piston moves in such a way that the pressure remains constant. cp=20.79 j k^−1 mol^−1 for a monatomic ideal gas, and that the number of gas molecules is equal to avogadro's number (6.022×10^23) times the number of moles of the gas. (a) what is the temperature of the gas after the energy is added? (b) what is the change in volume of the gas? (c) how much work is done by the gas during this process?
Answers: 3
You know the right answer?
Which is one factor that contributes to the formation of polar, temperate, and tropical zones?...

Questions in other subjects:

Konu
Mathematics, 28.05.2021 20:20
Konu
Mathematics, 28.05.2021 20:20
Konu
Mathematics, 28.05.2021 20:30
Konu
Mathematics, 28.05.2021 20:30