Physics, 08.12.2020 01:50 springtrap77391

8. Practice: Determine the total resistance of each of the following parallel circuits. Then use the Gizmo to check your answer. (You can calculate the total resistance from the current and voltage using Ohm's law,
or use the Ohmmeter to measure the resistance directly.)
A. A parallel circuit with a 20-ohm resistor and a 10-ohm resistor.
B. A parallel circuit with two 20-ohm resistors and a 10-ohm resistor.
C. A parallel circuit with a 15-ohm light bulb and a 20-ohm resistor.
D. A parallel circuit with two 100-ohm resistors and a 20-ohm resistor,
E. A parallel circuit with a 10-ohm, 20-ohm, 100-ohm and 200-ohm resistor

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 10:30, tay8556

The uniform slender bar rests on a smooth horizon- tal surface when a force f is applied normal to the bar at point a. point a is observed to have an initial acceleration aa of 20 m/s2, and the bar has a corre- sponding angular acceleration of 18 rad /s2. deter- mine the distance b.

Answers: 1

continue

Physics, 22.06.2019 13:20, Tess3492

It is reasonable to assume that the bulk modulus of blood is about the same as that of water (2.2 gpa). as one goes deeper and deeper in the ocean, the pressure increases by 10000 pa for every meter below the surface. if a diver goes down 80.0 m in the ocean, by how much does each cubic centimeter of her blood change in volume? give the answer in cubic centimeters (actually one cubic centimeter equals one milliliter).

Answers: 2

continue

Physics, 22.06.2019 18:30, hannahkharel2

Acar starts from rest at a stop sign and reaches a velocity of 25 m/s w in 4 seconds. determine the acceleration of the car. question 3 options: a) 6,25 m/s2 b)6.25 m/s c)100 m/s2 d)100 m/s

Answers: 1

continue

Physics, 23.06.2019 08:00, dootdootkazoot

What is the momentum of 70 kg runner traveling at 10 m/s?

Answers: 1

continue

You know the right answer?

8. Practice: Determine the total resistance of each of the following parallel circuits. Then use the...