Physics, 13.11.2020 04:10 ksiandua07

What affects the amount of electricity that can be generated through wind power?

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 01:20, Kjcampbell2

Your target variable is δf, the magnitude of the difference in frequency between the waves emitted from the sonar device and the waves received by the device after reflecting off the whale. write an expression for δf in terms of the relevant frequencies using the subscript notation introduced above.

Answers: 3

continue

Physics, 22.06.2019 09:00, montgomeryaevans

This is really important 1.which of the following prefixes represents the largest value? (2 points)gigahectorkilomilli2.which of the following types of graphs is best for plotting the mean, median, and mode of data? (2 points)bar graphbox-and-whiskercircle graphstem-and-leaf

Answers: 1

continue

Physics, 22.06.2019 17:30, giraffegurl

Distinguish between linear momentum and angular momentum

Answers: 2

continue

Physics, 23.06.2019 07:00, hockejoh000

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?