Physics, 30.10.2020 05:10 justinjoyner12p5ox1r

Put the following equipment in order from smallest to largest Marble Table, Chocolate Tempering Machine, Pastry Bag,
Sifter, Commercial Dough Sheeter, Steam Jacketed Kettle,
Rolling Pin, Parisian Scoop, Chinois, Pocket Thermometer,
Immersion Blender, Robot Coupe

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 16:00, amoakoh800003

As shown in fig. p3.64, a closed, rigid tank fitted with a fine-wire electric resistor is filled with refrigerant 22, initially at 2108c, a quality of 80%, and a volume of 0.01 m3. a 12-volt battery provides a 5-amp current to the resistor for 5 minutes. if the final temperature of the refrigerant is 408c, determine the heat transfer, in kj, from the refrigerant.

Answers: 1

continue

Physics, 22.06.2019 10:50, afonseca73

Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.

Answers: 3

continue

Physics, 22.06.2019 19:30, paulstanley972

Visualize the problem and identify special cases first examine the problem by drawing a picture and visualizing the motion. apply newton's 2nd law, ∑f⃗ =ma⃗ , to each body in your mind. don't worry about which quantities are given. think about the forces on each body: how are these consistent with the direction of the acceleration for that body? can you think of any special cases that you can solve quickly now and use to test your understanding later? one special case in this problem is if m2=0, in which case block 1 would simply fall freely under the acceleration of gravity: a⃗ 1=−gj^.

Answers: 1

continue

Physics, 22.06.2019 20:50, dondre54

Asquare 1m x 1m plate is shown below. all four of its edges are kept at 0 co. at t=0the temperature distribution is given by: y xtsins n75)=.a) using separation of variables determine the temperature distribution t(x, y,t)along the plate at any time t. b) discretize the heat conduction equation +=22222 txtusing a second-order centered difference scheme for the two second derivatives and a first-order forward euler scheme for the first derivative. using von neumann stability analysis, determine the stability criterion for the proposed discretization scheme in terms of , hand t. solve for the maximum allowable time step tmax

Answers: 1

continue

You know the right answer?

Put the following equipment in order from smallest to largest Marble Table, Chocolate Tempering Mac...