subject
Physics, 20.10.2020 04:01 ashlon98

A stonemason drags a marble block across a floor by pulling on a rope attached to the block as illustrated in the figure. The block is not necessarily in equilibrium. According to Newton's 3rd law, which case of the
following isn't considered an action-reaction pair?
200-
46.02.2
A) Force of rope on block - Force of block on rope
B) Force of block on ground - Force of ground on block
C) Force of mason on rope - Force of rope on mason
D) Force of block on rope - Force of mason on rope

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 20:40, cuavang55
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
image
Physics, 22.06.2019 08:00, KA115
What is a good example of instantaneous speed
Answers: 2
image
Physics, 22.06.2019 10:10, Kitty10101
Apair of 10μf capacitors in a high-power laser are charged to 1.7 kv. a. what charge is stored in each capacitor? b. how much energy is stored in each capacitor?
Answers: 2
image
Physics, 22.06.2019 11:20, leandrogarin37p2g5ds
Suppose a diode consists of a cylindrical cathode with a radius of 6.200×10^−2 cm , mounted coaxially within a cylindrical anode with a radius of 0.5580 cm . the potential difference between the anode and cathode is 260 v . an electron leaves the surface of the cathode with zero initial speed (v initial=0). find its speed vfinal when it strikes the anode.
Answers: 1
You know the right answer?
A stonemason drags a marble block across a floor by pulling on a rope attached to the block as illus...

Questions in other subjects: